DAITO CUD / GTR DRILLING & SAWING
The Ultimate Drill Saw Beam Lines.
DAITO CUD / GTR SERIES
CNC DRILLING & SAWING LINES
Multiple configurations to suit your factory type, budget, or production outcomes.
3 DRILL SPINDLES
CUD3C is equipped with 3 spindles. Each spindle is capable of high-speed carbide drilling, milling, tapping, countersinking and new high-speed layout marking.
INDEPENDENT TRAVELING DRILLS
Each of the 3 drill heads travel independently in all directions allowing all holes within range to be drilled without continually re-indexing and re-clamping the workpiece. This means much higher accuracy and higher productivity.
4 SIDE LAYOUT MARKING
New high-speed layout marking is 8 to 10 times faster than traditional scribe marking. The workpiece is stationary for maximum reliability and accuracy.
AUTOMATIC TOOL CHANGING
Three (3) Independent tool changers for each of the drill heads. This allows for a variety of uninterrupted drilling / marking operations with different tools.
PINCH ROLLER SYSTEM
The workpiece is fed by powerful pinch rollers located on the in-feed / out-feed sides of the machine. Even the heaviest workpiece is fed efficiently and accurately.
DUAL MEASURING DISKS
For precise measurements, twin disks work together. If the measurements of each disk vary, an alarm will be issued to stop the machine.
FLANGE HEIGHT GAUGES & SUPPORTS
The Flange height gauges not only support flanges, but also measure flange distortion that might remain after being vertically clamped.
WEB SUPPORTS
Web supports prevent thinner webs from bending under the pressure of drilling. This feature reduces drill bit failure and improves hole quality.
POSITIONING COMPENSATION
The workpiece positioning error caused by inertia is compensated by the positioning of each drill.
4 VERTICAL CLAMP ROLLERS
During the material feed, four vertical rollers clamp evenly to assist distorted material is firmly held down. Angles and flat bars are also able to be clamped as well as H beams.
PENDANT OPERATION PANEL
The pendant mounted operation panel can be easily swung to either side of the machine for easy setup and operation.
CNC CONTROL
Anybody can operate our user friendly CNC controlled machines. The intelligent CNC takes all the worries and hard work out of programming.
CHIP SWEEPER
After drilling, the chip sweeper cleans out built-up drill chips from the beam. Making sure no damage to the saw blade edge. Also ensures a clean and safe work environment with no chips spread throughout the workshop.
CHIP CONVEYOR
Drill chips built up inside the machine are automatically removed by the chip conveyor.
LASER MARKER
Irregular or manual positioning of the workpiece is made easy using the laser beam.
UNDER-WEB MARKING
For the welding layout marking, either scratching or scribing is available. (Sample photo is scratching)
WEB HEIGHT GAUGES
Two web height gauges check actual web height to allow automatic compensation for possible irregularities. (Optional)
MATERIAL LOADING & UNLOADING
Daito lift and carry cart system for loading and unloading to material stockyards. Gain increased productivity without having to rely on overhead cranes or forklifts.
SWIVEL OF BOTH DIRECTIONS
For miter cuts, the saw frame swivels automatically: max. 60 degrees clockwise, max.45 degrees anti-clockwise.
RIGID CONSTRUCTION
The saw frame and base are extremely heavy-duty ensuring a high level of accuracy, efficiency and maximum performance.
ACCURATE SWIVELLING
The saw frame swivel is driven by a geared motor and pin gears with little backlash; the swivel angle is always accurate.
WORK FEED ESCAPE
Even the fixed side of the vise escapes slightly for trouble-free work feed.
UNITISED MAIN VICE AND BASE
DAITO patented unitize vise can clamp the workpiece with 1 ton of clamping pressure, this reduces vibration of the cutting and increases blade life.
CHIP CONVEYOR
The raking type chip conveyor endlessly rakes chips out while allowing cutting fluid to drain back into the reservoir.
